The following is a table for the MaxPlus (MPM) Resolver Option 1 Termination to Compax Connections:
Feedback Connections X12 | ||||
Compax Feedback Connector | Option 1 Resolver Cable (170-24xxx)*** | |||
|---|---|---|---|---|
X12 Wire Function | Pin# | Pin Letter | Function | Wire Color*** |
+5 VDC (Motor Temp+) | 9 | N | THERM | Blue/White |
TEMP (Motor Temp-) | 10 | U | THERM | Black/White |
Sin+ | 13 | H | SIN | Yellow |
Sin- | 5 | F | SIN GND | Blue |
Cos+ | 12 | S | COS | Red |
Cos- | 11 | G | COS GND | Black |
REF+ | 14 | E | REF | Red/White |
REF- | 4 | R | REF GND | Yellow/White |
Connector Housing* | * | D | RES SHLD | Drain |
*The shield connections of the feedback cable should be connected to the Compax Feedback X12 header's metal housing (if possible).
***The wire colors may not apply to your cable. Option 1 resolver cable wire colors can vary, however, the wire function should be consistent among all cables. If your cable wire marker (labels) are no longer present or readable, please contact Parker.
Motor Power Connections X1 | ||||
Compax3 Motor Power Screw Terminals | Option 1 Motor Power Cable | |||
|---|---|---|---|---|
X1 Function | Phase | Pin Letter | Function | Wire Color |
Phase U | U | A | Phase R | Red |
Phase V | V | B | Phase S | Black |
Phase W | W | C | Phase T | Blue |
Ground | PE | D | PE GND | Green/Yellow |
Notes:
Motor Setup - The MaxPlus Option 1 motors are not included in the ServoManager software for the Compax. However, the Option 1 motors are included in the C3 ServoManager motor files for the Compax3. You can use the values in the C3 - MotorManager from within C3 ServoManager to help you configure your custom motor in the ServoManager software you use with your Compax. Once in the C3 - MotorManager, find your motor in the selection tree and the use the values to create your custom motor. Some additional notes you will need to set on the Compax:
...