Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Current »

If a TQ10 is exhibiting error conditions that cannot be resolved from the troubleshooting table in the user guide try the following test.

To verify that a TQ10 drive is functioning, remove all the devices connected to it including the motor. Then install three jumpers:

Enable IN to Enable GND
HALL GND to HALL1
MOTOR TEMP+ to MOTOR TEMP -

Reapply power.

The drive should power-up with no errors. Any error present at this time indicates that there is insufficient voltage or the drive needs to be returned for repair.

  • No labels

0 Comments

You are not logged in. Any changes you make will be marked as anonymous. You may want to Log In if you already have an account.