Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »

The E-DC does not have a enable/disable input. However the Remote input allows the user to mimic a shutdown. This input allows you to reduce current to a motor from a remote location. Reducing the current to zero allows you to mimic a shutdown, with zero current your motor should not have holding torque.

Remedies

  1. Connect pins 16 and 17 or use your Parker Stepper cable.

EDC DRIVE I/O CONNECTOR

  1. To reduce motor current to zero, short the CURRENT and REMOTE terminals together (with a wire). When the remote input is enabled, the open collector transistor internally connected to the REMOTE screw terminal will conduct to ground.

EDC REMOTE and CURRENT

  • No labels