Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

Your 690+ MUST have firmware version 4.X or higher to have the ability to clone the the drive and both drives MUST be the same rating. The drive that you are cloning to must have the same or higher firmware as the original drive.

To copy the parameters to the keypad you mush go to SYSTEM > SAVE CONFIG > SAVE CONFIG > OP STATION

This information is also found in the manual. Follow this QuickLink for the 690+ on Parker.com - (Manual, QuickStarts, Product Support, etc)

To load parameters to the new drive you must go to SYSTEM > SAVE CONFIG > RESTORE CONFIG > OP STATION

To save these new parameters to the drive you must go to SYSTEM > SAVE CONFIG > APPLICATION

Note - After successful cloning, no auto-tune should be required if the original drive had previously been autotuned successfully and not running in V/Hz mode which does not require auto-tuning.

  • No labels