Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Current »

The SSS command is an undocumented command in the Extended X Language (SX). This software switch command will cause the SX to jump to the Fault/Kill Sequence, which is defined by the XFK command, when one of two conditions happen:

  1. If the stop command, S, is issued to the SX.

  2. If a stop input, defined by

IN{n}D (where {n} is the number of the input), is activated.

NOTE: This command is only valid from Software Version -F2 or later.

  • No labels

0 Comments

You are not logged in. Any changes you make will be marked as anonymous. You may want to Log In if you already have an account.