SSS Command in the Extended X Language

Owned by Perla Madrigal (Unlicensed)
Last updated: Aug 08, 2024 by Eric Rojas (Unlicensed)
1 min read

The SSS command is an undocumented command in the Extended X Language (SX). This software switch command will cause the SX to jump to the Fault/Kill Sequence, which is defined by the XFK command, when one of two conditions happen:

  1. If the stop command, S, is issued to the SX.

  2. If a stop input, defined by

IN{n}D (where {n} is the number of the input), is activated.

NOTE: This command is only valid from Software Version -F2 or later.