Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Current »

The PPU of an axis is Stored in a Axis Parameters (P12288-P14199), i.e. Axis0 has its PPU setting store in P12375.

You also can check the PPU by using the following immediate mode command from the ACR card prompt.

When Axis 0 is attached to program 0 as axis "X" you could use "PPU X" when at the Prog0 prompt, else use "AXIS0 PPU" from any other prompt.

  • No labels

0 Comments

You are not logged in. Any changes you make will be marked as anonymous. You may want to Log In if you already have an account.