Homing Move Not Complete
- Perla Madrigal (Unlicensed)
- Eric Rojas (Unlicensed)
Owned by Perla Madrigal (Unlicensed)
Why can I not make motion after my homing move stops?
SYMPTOM:
In some rare cases, the homing complete bit will not be set even though the motion appears to stop. Status bit 5 , going home bit, will be set. Subsequent commands may get buffered or generate a *E respone, depending on the OS revision.
Â
REMEDY
The symptom is caused by the fact the controllr thins the homing move is still setteling. Please increase the value the EW variable before you attempt a homing move.
You check current value by typing 1R(EW)
You can chnage value by typing 1W(EW=xx) : where xx is the new desired value.
Â