/
How Can I Flash the LinkNet Techbox Firmware?
How Can I Flash the LinkNet Techbox Firmware?
1 - Connect to the Techbox (with either an Ethernet cable or the USB cable)
2 - Start DSE-Lite
3 - Choose the correct COM
4 - Check to see you are connected (It will say in the scratchpad to what the software is connected and what firmware is installed in the unit)
5 - Choose COMMAND - INSTALL FIRMWARE
6 - Click OK
7 - Choose Firmware version
8 - DO NOT INTERRUPT
9 - Check version (verify in the scratchpad that the new firmware is installed in the unit)
Related content
AC30 Firmware Revisions and Numbering Scheme
AC30 Firmware Revisions and Numbering Scheme
More like this
6053 DNET Techbox Firmware Incompatibilities
6053 DNET Techbox Firmware Incompatibilities
More like this
What Does "Net Fail" Indicate in DSE Lite When Using a LinkNet Techbox Module on My 690+ Drive?
What Does "Net Fail" Indicate in DSE Lite When Using a LinkNet Techbox Module on My 690+ Drive?
More like this
What Does "Net Fail" Indicate in DSE Lite When Using a LinkNet TechBox Module on My 590+ Drive?
What Does "Net Fail" Indicate in DSE Lite When Using a LinkNet TechBox Module on My 590+ Drive?
More like this
My 890 Control Board Locked Up When Updating the Firmware, How Can I Reset the Control Board?
My 890 Control Board Locked Up When Updating the Firmware, How Can I Reset the Control Board?
More like this
DSE Lite, Drive Firmware, and Project Compatibilities
DSE Lite, Drive Firmware, and Project Compatibilities
More like this