ACR-View: Mapping a Parameter to an Oscilloscope Channel

You can map a parameter value to an oscilloscope channel that is not in the drop down menu list. 

If you want to display a parameter on an oscilloscope channel that is not on the drop-down list, then you can manually map this parameter

You can't map a single bit to an Oscilloscope channel, but you can the parameter word, which makes up the bits. 

Below is a screen shot that shows how the channels are set default.   SAMP0 SRC is for channel 1, SAMP1 SRC is for channel 2, and so on.  If I wanted to change channel 1 to be P4200, then I'd add to my code SAMP0 SRC P4200. 

Open

8/3/2016 nc