/
6K Software - How to Disable the Power-Up Banner Message
6K Software - How to Disable the Power-Up Banner Message
To disable the 6K startup banner message, just address the unit to a non-zero value using the ADDR command. Only address zero will print out a startup banner message.
Example banner message:
*PARKER COMPUMOTOR 6K4 MOTION CONTROLLER
*NO REMOTE PANEL
To disable startup banner message:
ADDR1
*** This will disable banner messages on both communication ports on the 6K. ***
To enable start-up banner message:
ADDR0
, multiple selections available,
Related content
6K Troubleshooting - Scrolling Carrots with Motion Panel and 6K
6K Troubleshooting - Scrolling Carrots with Motion Panel and 6K
More like this
6K Misc - Daisy Chaining with 6000 or 6K Products
6K Misc - Daisy Chaining with 6000 or 6K Products
More like this
6K Troubleshooting - No Remote Panel Error or Power-Up SEQUENCE FAILURE
6K Troubleshooting - No Remote Panel Error or Power-Up SEQUENCE FAILURE
More like this
Removing the Splash Screen from the P9 or PS?
Removing the Splash Screen from the P9 or PS?
More like this
6K Troubleshooting - Motion Panel Loses Communication Periodically
6K Troubleshooting - Motion Panel Loses Communication Periodically
More like this
6K Misc- Completely Reset the 6K to Factory Default via Hardware
6K Misc- Completely Reset the 6K to Factory Default via Hardware
More like this